I can run a common ground to all 9 switches, and pass that ground through a rotary pot. Ideally, I’d add a rotary pot on the dash, so I can brighten the LEDs for daytime use, and adjust thdir brightness for nighttime operation. the problem is, they’re powered from the 12v supply, which must remain 12v for the accessories they supply, so I need to dim the switches on the ground side. these are better, but still a bit too bright. The boat was inoperable at night, because the blazing blue switches messed up night vision and obscured everything in front of the boat (along with a very poorly placed anchor light, incorrectly wired so it comes on with the running lights – a separate problem scheduled for my next fix.)Īnyway, I just replaced 9 blue LED switches with red LED switches. I bought a boat last year, in which the prior owner had installed LED tipped toggle switches in VERY BRIGHT blue. I hope this helps you with your next LED lighting project, make sure to check out the great variety of switches, rocker switches, toggle switches we have to offer. You can use two of our on/off/on switches, and wire them like this: This switch also has a built-in LED that lights up when it’s in the on position, so if you’ve purchased one of these, below is a wiring diagram showing how you would go about wiring this particular rocker light switch, remember to pay careful attention to the markings on the pins:ĭo you want to control one light from two switches? Let’s say you have a large RV, and want to control your lights from a switch at the bedroom as well as a switch at the kitchen. Scion OEM style rocker switch wiring diagram Amber (LED lights up when switch is on).White (LED lights up when switch is on).

Green (LED lights up when switch is on).Switches from Oznium Our rocker switches are available in:

5 pin micro relay pin out diagram